"Dragonborn" - Work Jacket (Ready To Ship)
S
€128 EUR
Skip to product information
3 left
"Dragonborn" - Work Jacket (Ready To Ship)
€128 EUR
Taxes included.
Shipping calculated at checkout.
Size Guide
Size Guide
Dragonborn Jacket Size Chart
European Sizing in CM
| S | M | L | XL | 2XL | |
| WIDTH (A) | 62 | 65 | 68 | 71 | 74 |
| LENGTH (B) | 63 | 65 | 67 | 69 | 71 |
| SLEEVES (C) | 58 | 59.5 | 61 | 62.5 | 64 |
Please note that the measurements provided in the
table may vary slightly with a margin of 1 to 2 cm on all measurements.
HOW TO MEASURE:
Take a jacket that fits comfortably. Lay it flat on
the ground and grab a measuring tape.
Width (A): Take measure from the stitching under
one armpit across the chest to the stitching on the other side.
Length (B): Take measure from the highest shoulder
point down to the bottom.
Sleeves (C): Take measure from the shoulder seam
to the end of the cuff.
Compare your measurements to the table above.
If you are between sizes or prefer a loose fit, take
the bigger size.
- 100% heavyweight 320 GSM cotton canvas
- Gorgeous red diamond quilted 100% premium polyester satin lining
- Insulated with cotton padding for extra warmth
- "01" + fire patches on the sleeves
- Embroidery on the front
- DTG print on the back
- Slightly oversized fit with dropped shoulders
- Ribbed hems and cuffs
- Two front pockets + one inner pocket
- YKK #5 metal zipper
Model is 182 cm and is wearing size L.
Washing instructions
Washing instructions
To protect the fabric and artwork, follow these steps:
- Turn the garment inside out before washing — this protects the print.
- Wash with cold water (30°C) using a mild detergent. Avoid bleach or strong detergents, as they can damage the fabric and print.
- Use the gentle/delicate cycle on your washing machine.
- Do not use fabric softeners — they break down both the fibers and the print over time.
- Air dry only. Lay flat or hang to dry at room temperature. Do not tumble dry, as heat can shrink the fabric and ruin the print.
- If ironing is necessary: use a low heat setting and iron inside out. Never press the iron directly on the print.
