"Shrine" - Oversized ZIP-UP Hoodie

€82 EUR

"Shrine" - Oversized ZIP-UP Hoodie

€82 EUR

Taxes included. Shipping calculated at checkout.

Zip Up Size Chart

European Sizing in CM

	XS	S	M	L	XL	2XL
WIDTH (A)	57	61	65	68	71	73
LENGTH (B)	65	66	67	68	70	71
SLEEVES (C)	64	64	66	66	67	67

Please note that the measurements provided in the
table may vary slightly with a margin of 1 to 2 cm on all measurements.

HOW TO MEASURE:

Take a zip-up hoodie that fits comfortably. Lay it flat on
the ground and grab a measuring tape.

Width (A): Take measure from the stitching under
one armpit across the chest to the stitching on the other side.

Length (B): Take measure from the highest shoulder
point down to the bottom.

Compare your measurements to the table above.
If you are between sizes or prefer a loose fit, take
the bigger size. If you want a more standard zip-up hoodie,
take a smaller size.

Size XS S M L XL 2XL

Preorder Item

This item is made to order. That means this item will only get made after you place an order and will ship only after production is finished.

Production time

6 weeks

Ships by

August 17th - August 23rd

Gathering orders

1 week

Production

6 weeks

Packing and fulfilment

Orders will ship soon

Shipped out

Check your email for the shipment information

470 GSM heavyweight French Terry
100% organic cotton
Two-way zipper
Kangaroo pocket
Oversized fit with dropped shoulders
Ribbed hems and cuffs
Advanced DTF prints

Model is 182 cm and is wearing size M.

To protect the fabric and artwork, follow these steps:

Turn the garment inside out before washing — this protects the print.
Wash with cold water (30°C) using a mild detergent. Avoid bleach or strong detergents, as they can damage the fabric and print.
Use the gentle/delicate cycle on your washing machine.
Do not use fabric softeners — they break down both the fibers and the print over time.
Air dry only. Lay flat or hang to dry at room temperature. Do not tumble dry, as heat can shrink the fabric and ruin the print.
If ironing is necessary: use a low heat setting and iron inside out. Never press the iron directly on the print.